Comunicate Motosim EG-VRC with real controller YRC1000

  • Hello, I'm trying to do a comunication between Motosim EG-VRC 2021 and YRC1000 . The only thing that I can do is to see the online moves. When I try to do a program transfer always show a failed. I cannot create a controller by network too.



    I researched about it , and there is any configuration to enable the transfer data ( but I don't have sure). What I found it was > start in Maintenance mode > System> Setup > Option function > Network function setting > Ethernet > to change 'NOT USED ' to 'USED' , but I cannot change it. So my question are , Is it right ? Is this the way ? How to change to 'USED' ? It does necessary to use yaskawa mode and set the paramenter ?

  • AD
  • Hi , you shuold check Lan network to see whether is it in used or not. Then try to ping the robot with your computer. After that, you can read chapter 9 in the MotoSim Manual which is on your MotoSim install folder.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now