I have a RS50N T-52 controller and am wondering if any one knows which switch and/or Zswitch needs to be on in order to use the Fixed Tool option?
Kawasaki Fixed tool Coordinate
- emcstang
- Thread is Unresolved
-
-
I have a RS50N T-52 controller and am wondering if any one knows which switch and/or Zswitch needs to be on in order to use the Fixed Tool option?
Please, try ZFIXED switch
You, also, should activate Fixed Tool zoption
P.S. Aren't T-controllers for Toyota factories?
-
Yes, its for Toyota.
-
Any additional options other than standard, maybe additional paid for options, please do not discuss about how to enable and set these options on the public forum.
Contact your local Kawasaki distributor in order to discuss and obtain additional options.
If you are using Toyota Controllers, they are usually configured by Kawasaki directly from shipment as they differ from general controllers in many ways.
Toyota themselves govern just exactly what options they require, so if the option is not installed, then Toyota should be contacted if you are looking at modifying any existing configurations.