Running / Fault Status Stack Light

  • I’m having an issue on A Fanuc LR Mate 200-ib RJ3i ,(Not a 30i controller)

    Looking to be able to turn on a green light DO[102] when SO[1] Cycle Start light is ON

    And turn on a red light DO[101] when SO[3] Fault Light is ON

    To signal running or error state on a Stack Light.


    Normally I would do this with BG Logic or mixed logic, Flags etc..

    But on this controller it doesn't have any of these functions.

    Interconnect is only [DI]to[DO], [DI]to[RO], [RI]to[DO] No [SO] [SI] or [ES] available in choice selection.

    Is there any easy way to accomplish this.

  • AD
  • What version is the OS? You can see that when you hit the utilities->Hints screen. I'm guessing V5.4.


    Do you have the RUN command available? You could setup a separate task to monitor IO and run the stack light.


    There was a thread going over running a separate task a couple of years ago here.

    Check out the Fanuc position converter I wrote here!

  • I'm not familiar with that controller but on the R30iA there is an output on one of the boards that indicates a fault, I think on the panel board. I assume a similar signal exists on the RJ3i. If you have the manual for your controller you could find that output and wire it into the red light.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now