Yes, you can run multiple tools in the bullseye. Each will be required to be set up at start. When running, you will have to manually change the tool in the quickset menu. After selection you can create a procedure that will check the current data of the current tool, evaluate then run the correct bullseye routine.
Something like this sample.
LOCAL PERS tooldata tdDummy:=[TRUE,[[-12.9941,0.00665184,365.226],[0.92388,-8.76E-6,0.382683,4.8729E-5]],[1,[-102.363,0.098,220.88],[1,0,0,0],0,0,0]];
PROC BE_Main()
CONST listitem BullsEye_list{5}:=[["","1 - "+"SHORT SWANNECK"],["","2 - "+"LONG SWANNECK"],["","3 - "+"STRAIGHT SWANNECK"],["","4 - "+"LONG SWANNECK (BENT)"],
["",sReturn]];
VAR num nDummy:=10;
TPErase;
nBullsEye:=UIListView(\Result:=button_answer,\Header:="BULLSEYE",BullsEye_list\Icon:=iconInfo\MaxTime:=nMaxtime\BreakFlag:=Err_Var);
TPErase;
tdDummy:=CTool();
IF tdDummy=tWG_Long THEN
sDummy:="tWG_Long";
ELSEIF tdDummy=tWG_Short THEN
sDummy:="tWG_Short";
ELSEIF tdDummy=tWG_Straight THEN
sDummy:="tWG_Straight";
ELSEIF tdDummy=tWG_Long_Bent THEN
sDummy:="tWG_Long_Bent";
ELSE
TPWrite "CURRENT TOOL IS: tWG";
TPWrite "THIS IS A 'DUMMY' TOOL";
WHILE nDummy<>0 DO
TPWrite "RETURNING IN: "\Num:=nDummy;
Decr nDummy;
ENDWHILE
RETURN ;
ENDIF
TEST nBullsEye
CASE 1:
IF sDummy="tWG_Short" %"BullsEyeProc_"+sDummy%;
CASE 2:
IF sDummy="tWG_Long" %"BullsEyeProc_"+sDummy%;
CASE 3:
IF sDummy="tWG_Straight" %"BullsEyeProc_"+sDummy%;
CASE 4:
IF sDummy="tWG_Long_Bent" %"BullsEyeProc_"+sDummy%;
CASE 5:
Service_Routine;
ENDTEST
TPErase;
RETURN ;
ENDPROC
