ERROR 38031

    Hi

    I have IRB2400L S4C.

    at present I have error 38031 resolver error for irb_1,arg1:1

    I have change the SMB board , change resolver with the other axis and check all cable but my problem not solve!\


    Something confused me "When I remove the resolver axis 3 from the connector my error change for axis 3 and not show axis 1 error" !


    Please instruct me


    Many thanks

    If you have a known good SMB & known good resolver, then the issue is the cable.

    Does this happen when before motor power is on or when you try to move the robot?

    Shielding issues can be hard to find. Make sure the cable shielding at the SMB is tied to ground with cable ties.


    I worry when you say you changed the resolver - removing the resolver from the motor will effect the motor commutation values.

    Can you verify the SMB is good?


    I've also seen this happen with a customer having various model S4C IRB2400 where the wrong wire harness was installed and while the wires checked good, the connections were incorrect.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now