Hello everyone.
I am facing a problem, any advice would be appreciated.
I deleted the existing system in the controller with X-start and then tried to reinstall it from the system builder of robotstudio, I had a copy of system with the serials numbers, in robotstudio.
The process starts normally, it downloads the system to the controller from ethernet service port and asks me to reboot to activate, so far so good.
The problem is from these step it can't install the system, it reboots, tries to install the system, reboots again and comes back to boot application.
In "select system" doesn't seem to have a installed system.
Does anyone know why this might be happening?
I have reinstalled the same system before on the same robot with no problem
I also tried installing on another compact flash memory card.
Any help or advice is welcome