AX20 PLC I/O

    Hi!


    I've been getting the hang of programming a AX20 nachi controller with a lot of success, but i cant seem to get the Internal PLC to read the physical standar input inside the controller.

    I used the standard i/o inputs inside the controller till now with the plc disconnect without a problem, but cant seem to get it work with the PLC reading it.

    A documentation about the plc programming would help me a lot but even a small example would be good to just have it work.

    Quote from bsrr

    In Constant->Signal->Hardware setting, Make setting for Input- PLC Through

    I've tried to tick the box for the Standard I/O group to be used through the PLC but after that it asks me to power cycle the controller and the setting is not changed after restart.

Advertising from our partners