How to conect to the robot FTP server?

    Thanks for providing your solution. That is odd, I was pretty sure that it should also work with port 2 (although I'm normally only using port 1).

    I did some research and found this thread. Check the last post. This does not explain why it didn't work with port 2 but it is an intersting statement.

    Quote from DS186

    Thanks for providing your solution. That is odd, I was pretty sure that it should also work with port 2 (although I'm normally only using port 1).

    I did some research and found this thread. Check the last post. This does not explain why it didn't work with port 2 but it is an intersting statement.

    Good thread!

    At the begining I was not able even over port 1 because the subnet mask was 255.255.255.128 on the robot side and I was configuring my laptop with the ip xxx.xxx.xxx.250. I changed to xxx.xxx.xxx.55 that was a spare ip and everything worked!

    Quote from DS186

    Some time ago I have created a short How To description on setting up FileZilla correctly to be able to connect to a FANUC robot. I can send you the document tomorrow when I am back in the office. It is in German, but that should not be a problem.

    hi , i am currently researching about the same issue and it would be pretty nice to see that document if you would be so kind?

    thank you so much!

    Quote from DS186

    Some time ago I have created a short How To description on setting up FileZilla correctly to be able to connect to a FANUC robot. I can send you the document tomorrow when I am back in the office. It is in German, but that should not be a problem.

    Hello DS186

    I just started to work with fanuc and I am also looking for a way to send files over ftp to the robot. If possible can you please also provide me your documentation?

Advertising from our partners