I am getting a SRVO-364 DCS PRMCR alarm anybody know a remedy or can attach a pdf to the DCS manual? The remedy i got from the robot is: by setting $DCS_CFG.$SYS_PARAM to 1, but in this case, position/speed check function can not be used. I did this and lost half of my advanced DCS package. It also says the cause: This robot model is not supported. I loaded core software and then loads system files from previous project into this robot along with the DCS settings, maybe there was a SYS_VAR that i should not have loaded?
SRVO-364 DCS LR-Mate 200iD 7L
-
JD_Mid-State -
June 23, 2022 at 5:18 PM -
Thread is Unresolved
-
-
Solution: The files i uploaded was from a different model robot, just like it said. Hope this helps somebody.