I did a quick test with a real robot to verify this. The speed is definitely limited when jogging the robot in Auto mode with an override of 100%. It looks like it is the same speed as with 100% override in T1.
Thanks for clarifying that, I expected some sort of speed limitation relative to normal jogging speeds.
In my opinion, the easiest solution (with no changes on the software side required) would be to use a remote mode switch with a suitable cable length suggested by rob76.
Unless such a switch is attached to the pendant, this will only relocate the problem.
Unless such a switch is attached to the pendant, this will only relocate the problem.
But you can install the mode switch to a better place near the TP. Maybe not perfect but it might be an improvement. The only option from FANUC I know which gives you the possibility to have the mode selection directly on the TP is "TP Mode Select" (J768). But as far as I know this option is not compatible with the R-30iB controller.
