Hi all!
I have Fanuc paint robot P-250iB. It has very long time for starting (about 10 minutes for blow out). But I use it for demo cell. How can i turn off this blow out or reduce blow out time?
Fanuc P-250iB reduce controller start time
-
Vlad222 -
May 26, 2022 at 8:50 AM -
Thread is Unresolved
-
You don't, unless you want to blow up.
It takes ten minutes because it is rated Class 1Div 1 for explosive environments. It has a ten minute purge timer.
The purge controller can be easily bypassed, but if you can't figure it out on your own, you probably shouldn't be poking around in the controller.
Edit:
I should add, it can be electrically bypassed. It is hardware controlled, no simple software change.
-
The purge controller can be easily bypassed, but if you can't figure it out on your own, you probably shouldn't be poking around in the controller.
Edit:
I should add, it can be electrically bypassed. It is hardware controlled, no simple software change.
Exactly, it's possible, look into the manual for electrical wiring.
Advertising from our partners
