i have an r30ib controller with srvo-348 that will not clear, i have checked the contactors behind the e-stop board and replaced the e-stop board, cycled power, and it will not reset. any suggestions on what to do next?
FANUC ROBOT SRVO-348 DCS MCC ALARM 0,1
-
CodyWoodard@TMSC -
May 13, 2022 at 10:08 PM -
Thread is Unresolved
-
-
I don't know what type of control panel there is, but you can control the emergency stop signals coming to the EM Card. There may be a signal coming that shouldn't be coming. This signal can be on the CRM72 cable.
-
Hello how do you thé problème i have tube samedi error
-
I have thé same error
-
Hey Cody - Is this a unit that was running, but randomly stopped? Or a Unit that is currently being powered to put into service?
There are a few jumpers on the E-stop board that if missing - can cause this error and produce some headaches when troubleshooting.