Kuka and MxAutomaion

    Hi guys! I need your help.I want to control Kuka robot using s7-1215 controller. Can I control using this PLC? or should be 1500 one?.I have these software and hardware.

    KR 10 r1100 -2

    KRC 4 Compact

    KSS 8.6.7

    KUKA.Profinet 5.0

    kuka mxAutomation 3.1.1

    WorkVisual 6.0

    I have integrated S7-1200F and KRC couple of times but that was not using MXA.

    MXA is a library that integrates into PLC programming software (AB, Siemens or Beckhoff).


    So... did you read the MXA requirements?


    and since you already HAVE everything at hand, you could try it too...

    1) read pinned topic: READ FIRST...

    2) if you have an issue with robot, post question in the correct forum section... do NOT contact me directly

    3) read 1 and 2

    Siemens has many PLC products that belong to families such as Logo, S5, S7...


    Large product families may have further branches.


    For example S7 has

    S7 - 300

    S7 - 400

    S7 - 1200

    S7 - 1500

    etc.


    MXA manual simply mentions S7 so any of S7 products should be fine

    1) read pinned topic: READ FIRST...

    2) if you have an issue with robot, post question in the correct forum section... do NOT contact me directly

    3) read 1 and 2

Advertising from our partners