Hi,
how long is your job name?
Could you post your job?
What controller was the job written on?
Why do you have a YRC pendant on a DX200?
Can you take a picture of the error and post the header of the job down to the NOP?
Display MoreHi All,
I am having an issue loading a program onto my Dx200 controller using the YRC1000 pendant. When i am trying to load the program it comes up with an "incorrect job name" error, I have changed the name of the job, as well as editted the name of the job within the program using NotePad++, however it is still coming up with the same error.
How can i load the program?
Thank You,
Brandon
If you are change job name with editor, you must input the same name for the job file and also in the job.
Input a name for job without any space.
Also check job syntax and line endings. It should be \r\n
there are also restrictions for symbols
If you changed the job name offline, ie saved as new with N++, make sure you changed the job name in the header informaton to match. (second line of JBI file)
