One of my students changed a tool frame that was being used in a previous written program, so when the cell goes into auto is using that tool frame as the data has been over written, i have gone back on back ups but when i try to open a VR or DG file they come up as binary, and i dont get any data out of it. How do i go about reading these files to get data out of them, or does anyone know how i can find the previous tool frame values?
Recover Tool Frame Data From BackUps
- BrandySnap
- Thread is Unresolved
-
What robot brand? Guess Fanuc?
You should post this question in the correct section of the forum. Not in 'General Discussion'.
-
Fabian Munoz
Moved the thread from forum General Discussion of Industrial Robots Only to forum Fanuc Robot Forum. -
Hi BrandySnap
Welcome to the robot forum
I moved your post to Fanuc
Did you check Summary.dg ? Also If you post one of your backups I can load it into Roboguide and get the info you need
-
-
1. Make a backup.
2. Load framevar.vr from old backup.
3. Now you can look for the old values.
4. Load framevar.vr from backup made at 1. Or leave it as it is, if you don't need any changed frames since last backup, and skip 5.
5. Change the frame to the value from 3.
Create an account or sign in to comment
You need to be a member in order to leave a comment
