Weld line table

    Hi,

    Does anybody know how to get the weld line table to show Amps and Volts when i am using channels on welder side. Or does it work only with online control set to robot. Might i be able to move the registers from welder feedback to the ones that weld line table uses in ladder? Does anyone know what these registers are?

    • AD

    If I understand this correctly, the welder is running in job mode. The robot is a transporter for the torch. It moves to a position and start a weld. The robot moves to another position and says stop the arc. All the weld parameters are in the welder.


    How are the controller and welder communicating? DeviceNet, Profi, E I/P, etc?


    What controller?


    What welder?


    End result is probably no or if you have the time to reverse engineer it may be possible.

    I know a thing or two, because I’ve seen a thing or two. Don't even ask about a third thing. I won't know it.

    It´s a kemppi a7 powersource ,devicenet over ethernet,YRC 1000(does any other controller have weld line table?)

    And yes the welder is in so called job mode.

    Yes, there are other controllers with weld line table.


    Not familiar with a Kempii to give you more info. Never seen one in the US on a robot.

    I know a thing or two, because I’ve seen a thing or two. Don't even ask about a third thing. I won't know it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now