Hi,
I have a KRC4 8.5.8 Kr180 r3200 pa. Yesterday we had a power outage in our factory then our kuka started to show the (1.jpg) error.
I followed a guide here and deleted the old SmartHmi.User.config and then smartpad never loaded hmi if i rebooted krc4.
I could start hmi if i went to RDP menu from smartpad and pressed connect. If i reboot krc4 i have to go to smartpad>rpd>connect it doesnt start alone.
I cant see krc4 robot in workvisual but ping is ok. It was ok before poweroutage.
PD: PLC-robot is working ok, i just cant connect to krc4 using workvisual (i cant change the project)