For a project I need to expand an existing twincat 3 simulation of a plc to be able to simulate the robot(s) it is connected to as well. Is there a way to have a simulation within twincat 3 send and receive commands/data that it would normally send/receive through ethercat to a motosim simulation?
Motosim twincat 3 interface
- ven
- Thread is Unresolved
-
No, Motosim does not communicate with the outside works (no I/O, no PLC communication).
-
No, Motosim does not communicate with the outside works (no I/O, no PLC communication).
until now I did not figure out what for is "external software" in motosim
-
No, Motosim does not communicate with the outside works (no I/O, no PLC communication).
Thank you for this reply. Guess I'll need to find some other simulation software that can do this.
Advertising from our partners
