Hi, i am working on communication via tcp/ip i am succesfully sending decomposed position with command BITS, is there any analog of this command? So i could use it to read input signals as a byte array?
Reading Data from Input Signals
-
Ilya Smolin -
December 1, 2021 at 10:11 AM -
Thread is marked as Resolved.
-
-
- Best Answer
You can use the BITS function:
number = BITS(starting_input_number, number of bits)
For example:
i.number = 1129
number_bits = 8
number = BITS (i.number, number_bits) it will read from 1129 to 1136 (8 signals)
-
Welcome to the forum........
Not 100% sure what you're asking.
TCP/IP is a communication protocol which sends/receives character string arrays.
The usual way of sending/receiving IO data is usually via a fieldbus protocol such as profibus, profinet, ethernet/ip.