How to change LBF to NM in spot weld application

arun_AR · October 18, 2021 at 8:57 PM

Hai ,

I’m facing prob while Checking the force calibration… the force units are in LBF

Can u let me know how to change to NM

Thanks in advance

**kwakisaki** · October 18, 2021 at 10:39 PM

Check Aux Function 0502 System Switches for SI.UNIT and toggle option.

arun_AR · October 19, 2021 at 11:26 AM

It is in Off condition only

**kwakisaki** · October 19, 2021 at 11:45 AM

If you cannot change it, it maybe built into the firmware or specification of the robot.

Is it a dedicated controller for Toyota or Ford perhaps?

Shubham Jain · December 13, 2021 at 8:36 AM

actually I can only change KN to KGF and vice versa, but not getting NM to LBF.

TIA.

**kwakisaki** · December 13, 2021 at 1:17 PM

Contact Kawasaki regarding this issue.

Advertising from our partners