Hello,
Do anyone have experience with communication between PLC and robot controller (DX200 or YRC1000) via Ethernet?
Please help for it.
Hello,
Do anyone have experience with communication between PLC and robot controller (DX200 or YRC1000) via Ethernet?
Please help for it.
I am in the same boat here. I think I remember someone saying that you have to email Techsupport@motoman.com to get access to the Ethernet I/P. This of course is after you have purchased the add-on feature of the Ethernet IP License. (If installed then there should be a sticker inside controller) See attached print.179298-1.pdf
I believe this is what you need to seen tech support (serial number info)
Also need to send them the warranty ID# on the front of the controller
Ethernet or Ethernet I/P?
Ethernet.
You need to be a member in order to leave a comment