Range Limit exceeded when define Analog (or Group) Analog signal range - Input Max value

Hello

When I try to change value for Analog signal range - Input Max value, I get Invalid real (0.000,9999.000)

I try to define 65535 as Input Max value - It's maximum from analog input from welding machine, defined by 2 Byte, 0 - 65535.

Similar robot cell, where Group signal is defined, there Input Max value is 32767, if I try to change this value to bigger or even same

there is error occurred (like on pic 3.)

So solution is config file for I/O, but does anybody receipt and order for steps how to apply settings?

Quote from hermann

Don't know the setup for welding, but:

on the diagramm the value of the analog input is given in Volt, think you won't get 65565 Volt from the welder. Either you have a digital interface to the welder or an analog, if you have an analog you probably will get 0-10Volt, or maybe 20mA. If you have a digital you will get the value of 65565.

Signal from Welding Machine is over EthernetIP from Abicor Binzel Robot Interface iROB-RI3000 card.

At Welding Machine 2 x AI - programmed 2 x AI not programmed and 10 x AO, 0 - 65535 (2 Byte).

In this moment I have from DI169-DI184 (2 Byte), 00000000 10010010, DEC 18688,

WMAO 2. Welding Voltage, in stand by here is ~ 14,26 V as feedback.

Hi,

in this moment I can't weld but I can activate Piece search and on wire I get voltage, this voltage is 49,1 VDC. DI from Ethernet/IP card are static no changes when turn off or turn on Piece search.

By my humble opinion if AI/AO are defined any definition of DI/DO is excessive and useless.

I await some answer from Abicor Binzel about this.

So, I try some combination,

Mapping 79.55 LSB, MSB

0/1000, 0/100

Piece search OFF / ON

1.0 / 0.9

0/50, 0/50

Piece search OFF / ON

10.0 / 9.4

50/0, 0/50

Piece search OFF / ON

40.0 / 40.6

500/0, 0/50

Piece search OFF / ON

49.0 / 49.1

Mapping 79.52 MSB, LSB

0/50, 0/50

Piece search OFF / ON

10.0 / 12.5

50/0, 0/50

Piece search OFF / ON

40.0 / 37.5

0/10, 0/50

Piece search OFF / ON

50.0 / 62.5

I need to seat and find why I getting this values.

When I read out 0.0 and 49.1 that will be OK.

Ideas comes when you start to type question.

with active

Mapping 79.55 LSB, MSB

conversion 10.0/0 to 0/800

and winning combination give

0.0 when Piece search id OFF,

49,2 when Piece search is ON.

With digital voltmeter measuring 49.1 VDC.