I have a Fanuc R-J3iB controller and in the IO list I couldn't find the FLAGS option
please help to find this
FANUC FLAGS option is not showing
- shriraj lonkar
- Thread is Unresolved
-
Check the following system variables. Set use flg to 1 or true, and set num flg to however many flags you want available.
$MIX_LOGIC.$USE_FLG
$MIX_LOGIC.$NUM_FLG
-
Check the following system variables. Set use flg to 1 or true, and set num flg to however many flags you want available.
$MIX_LOGIC.$USE_FLG
$MIX_LOGIC.$NUM_FLG
Sorry but I could not these variables in my TP
is there any other way
please help
-
Probably is not available on that older controller version.
Instead you could use the internal mem port. Set a block of DO's to rack 0 slot 0. Then you will have DOs that act just like flags.
-
-
Probably is not available on that older controller version.
Instead, you could use the internal mem port. Set a block of DO's to rack 0 slot 0. Then you will have DOs that act just like flags.
can I use group IO to act like as flags
-
A DO is a boolean just like a flag.
A GO is an integer.
You can configure either DO or GO to rack 0 slot 0.
-
Flags seems to be a part of mixed logic and is an option on a RJ-3ib controller.
As far as I know it is a free option, but is has to be installed when installing the core software. (it has to be in the orderfile)
I don't know if it is possible to install it afterwards.
But the trick from HawkME is excellent when you only need the flags.
Advertising from our partners
