Hi everyone, I was wondering if it is possible to see the current in the External Axis motor on SmartPad ?
KRC4- Monitoring current of External axis
-
MertOzer -
August 27, 2021 at 4:51 PM -
Thread is Unresolved
Hi everyone, I was wondering if it is possible to see the current in the External Axis motor on SmartPad ?
like most things this is well documented - just read system variable manual.
to check motor currents (as %) you can use Single Variable Monitor and variable $CURR_ACT[]
I'll be carefull next time when I read the document Thank you sir!