• Newbie you have been warned. I was tasked by a supervisor to clean up some existing programs. All I did was rename a few programs and put A_ in front of the name of the program. For example A_Main. Now when I select that program to run it. It automatically reverts to the old program. It is labeled Main. Now when I go into teach mode with the pendant I can go all the way through the program. Any help is much appreciated. It is in local not remote.

    Fanuc Robot r-j3ib

  • Problem resolved: under System/Config we were running a cycle start monitor program for autoexe took that out and replaced with A_Main. Thank you all for your help.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now