Hello
I joined for the first time.
I'd like to inquire about a phenomenon that I've never seen before.
Model: ZX165L
controllers:E-CON
Manipulation Content
1. Encoder Rotation Reset
2. Zeroing
Problem situation
1. The encoder settings of JT5 and JT6 at zero point are different from the current values (JT1~JT4 are the same).
2. e.g.) Large numbers other than 1-10 such as the set value of 268411111 -> the current value of 268433333 are different.
If the encoder rotation was reset and zeroed, shouldn't the encoder's current value and set value be the same at zero point?
It also matches zero position when operating in zero degree position.
What is the cause?