Visit our Mainsponsor

Roboguide simulation : Part Random Offset (Read from PR)

VHS · 2021-07-26T20:00:23+02:00

Hi everyone ! I have a question about Part Random Offset in Roboguide. I would like to be able to make a part appear in a different place on my conveyor. To do this, I configured the Part Random Offset to move my part according to the value of the PR [99]. However, in simulation, I always see my part in the same place. How can I solve this problem? Thank you !

VHS
Jul 26th 2021
Thread is Unresolved

VHS

Member LVL 5
Reactions Received

2

Trophies

2

Posts

35
Jul 26th 2021
- #1
Hi everyone !

I have a question about Part Random Offset in Roboguide.

I would like to be able to make a part appear in a different place on my conveyor. To do this, I configured the Part Random Offset to move my part according to the value of the PR [99]. However, in simulation, I always see my part in the same place.

How can I solve this problem?

Thank you !