I have a similar problem. Got a servo bzal o62 alarm but can not get to the screen to clear alarm. I replaced all the batteries. What am I missing. ? Here is a snap shot of what is on the screen r j 3 controller
servo 062 alarm cannot get past this screen or to clear alarm
- ktmark
- Thread is Unresolved
-
Make sure that $MASTER_ENB is set to true.
-
Go to the systems variable screen. Menu>System>Variables and look for the $MASTER_ENB variable first as pdl mentioned.
-
If you have password protection and are not logged in it will not show up. Additionally, if your quick/full menu toggle is on quick, it will not show up.
To clarify, SYSTEM does not show up unless on full menus.
-
Press the FCTN key. See Quick/Full menu. Select that and enter. Your full menu should load up.
Advertising from our partners
