Hello Specialists.
I have problem with axis 7 by FEE.
When I move with axis 10cm position taken from actual position on kcp vs 4,5 cm in real.
In append photo of gear box parameters.
Hello Specialists.
I have problem with axis 7 by FEE.
When I move with axis 10cm position taken from actual position on kcp vs 4,5 cm in real.
In append photo of gear box parameters.
Enter the correct gear ratio into $RAT_MOT_AX [,] for this axis. This machine data is found in R1/$machine.dat.
Fubini
Fubini.
I have no change by modification RAT_MOT_AX. Same offset position by encoder vs real distance
cold boot?
Describe in detail the steps you did to change it.