I get the following status notification :
RSI I/O Configuration files not found.
Does someone has any idea how to debug this issue?
I get the following status notification :
RSI I/O Configuration files not found.
Does someone has any idea how to debug this issue?
As Johnny 5 would say... Need more input..
Can you elaborate on this?
Kss version, rsi version, and more information on what you have been doing and what your trying to do, check the READ FIRST at the top of the forum
Robot: KR6 R700-2
Controller: KRC5 Micro Controller
KSS version: 8.7
RSI version: 5.0
I am just trying to initially trying to setup the robot by connecting hardware and all switches and trying to set up the smart HMI interface.
I was able to solve status notifications: External Emergency STOP and other status messages.
But this RSI I/O configuration file is missing, this error is persisting.
Without solving this error, I am unable to on the drivers in even T1 mode and try to move the robot.
I will attach the image which shows the corresponding error.
OK, try checking the file tree in work visual and see if the file exists,
Have you got the kop files loaded in work visual?
If I were you, id remove rsi from the work visual project for now, solve your other issues, then come back to rsi
Removing rsi and reinstalling it might help you
Did rsi come pre installed on the robot or have you done it yourself?
RSI came pre -installed on the smartepad2
No I have not loaded kop files in work visual.
How do I transfer kop files that are smartepad2 to workvisual?
Look on the D drive in the option file folder, copy them to a USB stick, or if your networked goto your robots ip /d on your pc
You need to be a member in order to leave a comment