S4c+ M2000, Welding PI Board 0501700880
-
robiman -
June 14, 2021 at 4:31 PM -
Thread is Unresolved
-
-
You should have 24V at the X2 CAN Bus connector on the PIB Module between pins X2-1 (0V) & X2-5 (+24V). That should at least get the MS turned ON.
-
That was what i have checked first. and Yes i have 24V , I have also remove the housing, but in the card i cant see any Fuse.
-
Think you also should plug in TB1, the upper left connector. There is included the power supply for the logic.
-
Think you also should plug in TB1, the upper left connector. There is included the power supply for the logic.
Yes. 28VAC between TB1-4 & TB1-5. If it's missing, check the 10W limiting resistor on the transformer primary.
-
The Card runs.
The elektrican found a small fuse.
i mean on the welding equioment
i self was not on site, they tould me torday morning
Thanks all for help