When I run a program in remote when it hits the end program it proceeds to restart the program and not stop
Motoman yaskawa looping in auto
-
AnthonyZ -
June 1, 2021 at 6:33 PM -
Thread is Unresolved
When I run a program in remote when it hits the end program it proceeds to restart the program and not stop
Change the setting under SETUP, OPERATE COND.
insert a label *TOP and a jump to *TOP as the last line in your job.
insert a label *TOP and a jump to *TOP as the last line in your job.
Done by noob.
See 95devils answer