Dear all,
i am having S4C, S4C+ controllers.
can please guide me how to take backup and download the backup with Floppy Disk Drive USB (FDD-UDD-EX144,
3HAC041748-001).
every power cycle i loosing backup please guide me.
thank & regards
Rajashekar Reddy. B
For the S4C+ controllers, you should replace the battery pack in the lower part of the Computer Unit. Until then, use the shutdown procedure found in the User Manual found >here< on page 12-22.
Backup & Restore start in the section before that on page 12-16.
S4 backup and restore work the same. I assume the 2 controller batteries in the S4C are good or you would also lose system software at power down.
For upload, download I can remember an option NFS client for the robots. If they have that option and a network card you can setup a NFS server on your laptop, and load programs over this NFS connection. But setting up the NFS server isn't that easy.
For s4c+, may be a ftp server on the robot was standard.
For upload, download I can remember an option NFS client for the robots. If they have that option and a network card you can setup a NFS server on your laptop, and load programs over this NFS connection. But setting up the NFS server isn't that easy.
For s4c+, may be a ftp server on the robot was standard.
For the S4C, it needs a DSQC336 Ethernet Board installed and Ethernet Services option along with the NFS server in the laptop/pc.
The S4C+ has the service port ethernet connection. Crossover cable to laptop/pc running Filezilla client.
For the S4C, it needs a DSQC336 Ethernet Board installed and Ethernet Services option along with the NFS server in the laptop/pc.
The S4C+ has the service port ethernet connection. Crossover cable to laptop/pc running Filezilla client.
Dear sir/madam,
thanks for your replay.
****************************************************************
i am using cross over cable in below link please conform configuration.
https://www.google.com/imgres?imgurl=…QMygEegUIARC8AQ
****************************************************************
in my laptop windows 7 pro. i downloaded and installed filezillasoftware from below link.
https://filezilla-project.org/download.php?platform=win64
****************************************************************
i am following tutorial video in below link
****************************************************************
in this video showing in general:
HOST :
PORT :
protocol:
Encryption:
login type :
user:
password:
what is the default address for S4C+ controller.
***in my controller service port available.
*****************************************************************
I am waiting for your replay
*****************************************************************
thank & regards
Rajashekar Reddy. B
I'm a couple of weeks from an S4C+ and usable non-network laptop but see if this helps:
Just from memory - with Filezilla and the S4C+, I always used 'abb' for User ID and 'abb' for the password but I seem to remember it would accept anything.
