Hello All,
does anyone have the pinout for the X19 of a KRC1, please?
Caution...it is called X19, but the plug is not circular as in KRC2s. It is rectangular.
Many thanks in advance
Hello All,
does anyone have the pinout for the X19 of a KRC1, please?
Caution...it is called X19, but the plug is not circular as in KRC2s. It is rectangular.
Many thanks in advance
Thanks very much MOM
We are talking about the attached, correct?
I find it difficult to understand which number corresponds to which compartment of the connector.
For example, 1, 2, 3 & 4 appear four times in the pinout, but which one is which on the plug.
Apologies for my ignorance
I understand the problem and I will look thru my very old documents to find a better schematic.
just read schematics for your robot system...
you can see the signal names as well as wire colors on the cabinet side.
this could be very useful to resolve any doubts.
Aha!
Thank you both very much!
Do you have the original cable from kcp1 ?
If yes check the colors
You need to be a member in order to leave a comment