Good afternoon,
I'm having trouble with my Fanuc.
After about 4 hours of constant use, the fanuc shuts down on its own every 5 minutes.
What can be causing this happen?
We use this robot for thermal spray application.
Trouble with my fanuc shutting down
- Joe Plasma
- Thread is Unresolved
-
Lemster68
Moved the thread from forum General Discussion of Industrial Robots Only to forum Fanuc Robot Forum. -
The robot model and controller revision/model are relevant information necessary for anyone to be able to give you good help troubleshooting. What is in the error log upon restart? Are there high ambient temps?
-
-
I am guessing that it is overheating. Have you looked at the transformer in the back of the controller?
-
Do you clean out the controller periodically? Our RJ3 controllers are in a dusty area and even with filters on all of the controller fans some dust gets in. We blow them out with compressed air periodically to prevent overheating.
-
Are there any fault messages on the pandant ?
-
Create an account or sign in to comment
You need to be a member in order to leave a comment
