Good afternoon,
I'm having trouble with my Fanuc.
After about 4 hours of constant use, the fanuc shuts down on its own every 5 minutes.
What can be causing this happen?
We use this robot for thermal spray application.
Good afternoon,
I'm having trouble with my Fanuc.
After about 4 hours of constant use, the fanuc shuts down on its own every 5 minutes.
What can be causing this happen?
We use this robot for thermal spray application.
The robot model and controller revision/model are relevant information necessary for anyone to be able to give you good help troubleshooting. What is in the error log upon restart? Are there high ambient temps?
The Unit is an RJ3 controller and the robot is an Arcmate 120i.
I am guessing that it is overheating. Have you looked at the transformer in the back of the controller?
Do you clean out the controller periodically? Our RJ3 controllers are in a dusty area and even with filters on all of the controller fans some dust gets in. We blow them out with compressed air periodically to prevent overheating.
Are there any fault messages on the pandant ?
You need to be a member in order to leave a comment