Hi everyone
My XP5/XM5 connector just broken during transport.
Is there any replacement option on the connector? Or I need to replace the whole motor
A4 and A5 axis work fine, no problem
XM5/XP5 connector
- Philong2005
- Thread is Unresolved
-
The simple solution is to use some special aluminum welding/brazing rods
that is a aluminum-zinc alloy(melts about 400 °C) and solders aluminum alloys very good and it is much harder than aluminum(because of zinc content).
The only tools you need is a propane gas(mapp gas) & an stainless steel wire brush.
Guarantee result..
https://www.instructables.com/How-to-weld-aluminum/
External Content www.youtube.comContent embedded from external sources will not be displayed without your consent.Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy.Before apply any heat you must remove the connector with plastics/cables etc
Advertising from our partners
