The Mitsubishi RV-2AJ I just got working seems to have a couple of positions not quite correct. I was wondering I I can just adjust a couple of points on the program that I can open and it will be fine or what I have to do to get them corrected. I did not write this program nor have I written one for this robot. Therefore I'm a little leary about doing so. Any thoughts on this?
MItsubishi RV-2AJ Positioning issues
-
jakegaspari -
April 9, 2021 at 1:35 PM -
Thread is Unresolved
-
-
if this is the same robot from other thread it would be miracle if all positions would be ok
just open program, reach desired position and teach it, if you have RT toolbox on your computer you should backup data before any changes.
Also you can try to run program in manual via debug, it should help you understand the the program and prevent colisions in automatic mode