Kawasaki TP not displaying anyting

Power off Controller and set dipswitch 1 and 8 ON for 1GA/1HA board and power back on.

Does teach pendant/KCWin display message?

DO NOT SET ANY VALUE - JUST POST BACK RESULT?

Power off, Put dipswitch on 1GA/1HA back to just no. 1 ON only.

Unplug Interbus Card from Rack and Power up again.

When was battery last changed?

Do you have any other spare boards you can try?

Do you have file save from previous working?

Well, if the above information is all correct, it appears the 1GA/1HA is damaged.

Can you pull the 1GA/1HA board out and take a picture of the front side of the board?

Can you tell me what harness labels are connected to which 1HP connections?

Quote from žiga

I have a kawasaki robot (ZX300S F) with (C42F-A001) controller and it was running perfect now i tried to turn it on after few weeks and it displays error on 1Hp board (RED LED) and also on TP there is nothing just backlight is on.

You mentioned this, then later you mention this:

Quote from žiga

We bought new battery because it was missing from the controller i also mesured it and its charged.

There was no work done on robot yet.

This does make sense........please explain more of background of robot, I know it is ex Jaguar system.

Do you have backup made from when it was working?

Ok, you can put 1GA back in, make sure no bent pins at the back.

1HP connections appear correct.

What I cannot understand is you said it was working, then you say battery was missing......

1. Please explain more of background of robot, I know it is ex Jaguar system?

2. Do you have backup made from when it was working?

Ah so it's this Controller again..................

The last time we spoke, this was apparently working.....was battery installed then?

Please explain:

- RS232 cable you are using - Pin out of cable.

- KCWin32 Settings you are using.

- Which ports are you connecting to using RS232 cable.

- Can you show me picture of MFP (lift flap underneath).