S4C ArcWare

Hello,

I have a 2700-2 / 02 system,

Robot 2400/16,

I'm building the same system inside the robot. system id same.

But arcware schedule, arc speed, weave options occur differently.

definition that should be.

PERS welddata wd1:=[1,10];

PERS weavedata wv2:=[2,4,0,0,0,0,0,0,0,0,0,0];

but that's how I introduced it.

PERS welddata wd1:=[1];

PERS weavedata wv2:=[2];

When I enter options 2 and 3, it gives a syntax error.

possibly different version of arcware.

While searching, I found versions 2.0, 2.1, 3.0. but they all had the same problem.

i saw the option arcware plus in another system. I saw 2700 / 2-56 version of the system on another system. Is it related to the system version or to the arcware option? array definitions are wrong. The array option cannot be added.

Quote from robiman

i mean the definition from the welddata and weavdate is depend from the configuration the arc System.

have you verify the proc.cfg?

have you make a P-Start? it is important in S4c+ Systems

the working system was backed up while the robot was on. I get this error when I restore the backup file.

Quote from Skooter

Try the P-Start and then load in the backup.

I tried, but it didn't work.

Quote from Skooter

The /02 on the system disk pack would indicate it is version 02.

The last version BaseWare 3.2 was 56.

I would try a newer version disk pack to see if it would help.

In the past, ABB tech support would supply a link to download the disk pack.

Note: You cannot load BW 3.1 after loading BW 3.2 as it will corrupt EEPROM on the DSQC373.

Display More

yes it upgrades eeprom when installing.