Hello. I am working with some brand new Fanuc robots, all of them are SYSTEM R-30iB PLUS controllers.
'UD not detected' is the notification within the FILE Menu.
I am having a lot of difficulty getting the robot to recognize any USB drive at the door port (UD1:), and regardless of the size of the drives from 2 MB all the way up to 8 MB. This problem does not seem to occur at the TP port, (UT1:), but I cannot always assume availability of UT1
JRS 16 is properly seated into the Main Board.
I have tried using the robot itself to format the USB drives, no success. Format... yes. Improvement... no.
The software is HandlingTool V9.30 P/12 7DF3/12 ARC Mate 100iD
The manipulator (not that it should matter) is M-10iD/12
Doing a re-start helps, but what a pain
Thank you in advance.