Hello robot-forum,
I have a KR C4, KSS8.6.6 controller that seems stuck on a invalid project config, several menus dont open with a message of inicialization error, like backup configuration, safety configuration.
Machine configuration says no project is active.
There is a red cross over the projects icon.
When i try to activate a project, either the inital project or a new from workvisual(V6.0.12), an error is thrown:
QuoteAn error occurred during activation.
Project not ready! Controller: <PCRC-3LW89UTRSO(localhost)>
QuoteWhen i try to restore to a restore point, its the following error:
An error occurred during restoration.
Unknown error during project activation of restored project 26110802...
In both cases the first message on the message list is that it failed to create a restore point.
I suspect the backup fails because the controller is in an invallid state, but i cant fix it because it tries to create a backup before a project is activated.
Can I deactivate the automatic restore point creation?
Any other possible causes?