Hello guys, i am trying to map signals on this board to send them further to a PLC:
If I put 24V on the input side the signal is detected by the robot, but i can not get the card to output 24V.
Maybe I am mapping the signals wrong - I am using RACK 0 SLOT 1 for both I/0 (nothing else works)
EDIT: The robot is mapped correctly, BUT the output voltage is 0.5!
Is there any conventional way (without transistors) to switch a contactor with 0.5 volts?
FANUC R-30iA - Board model 1761998 - A1