Add DSQC328 I/O Card & Declare I/O on ABB S4C

Hi, Shane! Thank you for your quick start guide!

I bought a DSQC327 board on ebay recently, connected it to an X9 CAN port inside a cabinet. Everything went well, both ns and ms leds on a remote module are lit, no errors after addind an IO board. As I assume, the module is working, yet I have one question about outputs activation. Here I post some photos of my setup. Can someone tell me if everything is ok? Cause now I do not see any output leds switching while exequting DO_set instructions... Should leds react with no load connected to DO output?

You need to wire in 24v output power.

Did it. Now everything works. I tied an output to a tig torch button and made some test welding.

Next goal is to make a wire feeder and a current regulator controlled by analog outputs of an IO board...

If you didn't fix it already, the Units parameters for the Combi I/O at address 11 should be 16-Digital Inputs, 16-Digital Outputs, 2-Analog Outputs.