Hi,
Thanks in advance for any help. I've seen this problem described here, but without a resolution. It's an ArcMate 210, Rj3, and Powerwave 255M/STT.
I've got a Fanuc/Lincoln weld cell. I can't strike an arc, or feed wire from programs, or manually. At power up I get the message ARC-204 Arclink ch1 avail. I have the necessary IO mapped to rack 90, at the proper range. I can turn on the gas from a program, it's on an RO.
The cell has been down for a while, after the breakdown, the Control board, and Digital power supply board were replaced. On control start, I see no ArcTool setup option.
Cheers,