G2 manuals

Thank You

thank you Skooter.

Guys I recently had to service1 of our Panasonic robots for the dead battery issue and subsequent reset problems that arise from it.

In post #3 from skooter he put a link to service manual sm00037EO1.pdf. On page 6-8 of that manual the procedure to jump the pins is NOT correct. Ya need to jump the pins on the jumper terminal itself. NOT the pins between the header and jumper terminals as the picture seems to indicate.

Then you line up the positions of the axis to reset and go to "teach axis by pendent" . I will try to attach the full "correct" procedure as I received it from Panasonic.

Panasonic robot reset procedure.docx

Quote from Skooter

YA-1RA Hướng dẫn vận hành

Legend! Thanks for the manuals, I just bought one at auction, very excited to get it powered and find out if it works!

Yes, thank you very much for these manuals.... Greatly Appreciated!!!

Thanks for sharing

Anyone have a Panasonic Miller G2 GII ARC Sensing YA-1RPSA2 manual? Looking for more details on seam track/arc sensor setup.

Anybody has Ethernet IP module for the G2 controller?