Hello,
I need help on Roboguide!!!
I can't open or create a new cell, the following message appears: "Unable to open workcell, the read-only attributes cannot be cleared."
How do I solve it?
Error open workcell Roboguide
-
M1chilino -
August 4, 2020 at 9:37 PM -
Thread is Unresolved
-
Did you install roboguide as an administrator? Are you running roboguide as an administrator? If you answer no to either of those questions, you WILL have issues.
-
Are you running RG as administrator?
-
Did you install roboguide as an administrator? Are you running roboguide as an administrator? If you answer no to either of those questions, you WILL have issues.
yes I am doing this
I re-installed, but the error persists
-
Are you running RG as administrator?
yes, I do
-
Can you try clearing the read only attributes from your cell from windows?
-
Is the workcell in it's default location (C:\Users\userName\Documents\My Workcells)? I've had this problem trying to open a workcell from a network drive before.
-
Is the workcell in it's default location (C:\Users\userName\Documents\My Workcells)? I've had this problem trying to open a workcell from a network drive before.
yea. I also can't create a new cell
no results.
-
Can you try clearing the read only attributes from your cell from windows?
I clear the attributes, but it still doesn't work. I can't open or create new cell -
What is the Roboguide version?
Are You trying to create a new cell from a robot backup, or from RG default configs?
-
Hi! I have the same issue now, all of a sudden. Do anyone have an update on this issue?
-
Hi! I have the same issue now, all of a sudden. Do anyone have an update on this issue?
After searching, I realized that i had this problem after deleting the registry keys from the computer. But the only solution i found at the moment was to format the computer.
-
Okey. Where are those registry keys located by default? Because I am sure I haven't deleted anything. Maybe that location is read/write protected and that is causing this issue?
Read/write privileges can be changed by the central IT department and since this is a software that is not distributed by IT they have no clue about how their changes might affect Roboguide.
-
Hi,
I had the same issue. My solution was;
Go to "Virus and Thread Protection", select "Ransomware protection"
then set "Controlled folder access" switch to "Off"
-
Hi, I got problem on opening the workcell too, and the issue was: my laptop wasn't connect to internet and my default project location is an online OneDrive folder !
I change the path to a local destination and connect to internet solve this problem.
Advertising from our partners
