400 I believe.
It can be changed to 999 in a controlled start. If you need more than that there are super secret tricks to do so.
Thank you so much 
Super secret trick was not necesseary ... for now
It can be changed to 999 in a controlled start. If you need more than that there are super secret tricks to do so.
HawkME,
Anyway you can PM the super secret trick to me?
Thanks,
-Phil
please look option R830
I am currently looking for the sysvar to set te maximum number of registers. I need to get more than 200 (iRPickTool is accessing 216 and 217, but the robot is not configured for that ;)) - I can find maxnumtasks, ualmmaxnum, etc... but cannot find a numregmax kind of variable... - am I looking at the wrong place? is it more obvious in some config-menus?
Sometimes you only have to speak loud. I found the "obvious" config menu in controlled start (just had to go to 0-NEXT o.o) and find the PROGRAM SETUP screen... from there it is straight forward :p
You can set it in a menu with the robot in a controlled start.
[*POSREG*]$MAXPREGNUM Storage: CMOS Access: RW : INTEGER = 200
[*NUMREG*]$MAXREGNUM Storage: CMOS Access: RW : INTEGER = 500
[*SYSTEM*]$MAXUALRMNUM Storage: CMOS Access: RW : INTEGER = 900
[*SYSTEM*]$MAX_DIG_PRT Storage: CMOS Access: RW : INTEGER = 4096
1. CONTROL START - PROGRAM SETUP
2. Numeric Registers - 999
why lose my picture every time....
