Moving I/O labels

    Hello Everyone,


    I am currently working on the labels or comments for the I/O's on our DX200's. I was wondering if there is a way to move these from one robot to another? Instead of typing in each individual I/O on each Robot. Our I/O's are the same on each of the Robots. Trying to speed up the process.


    Thank you.

    Hi,

    if you are talking about the "nickname" that you give to the IO signal they are stored in the IONAME.dat file.

    For the variable they are stored in VARNAME.dat file.


    Before load them in another controller, do a safe backup.

Advertising from our partners