Suddenly one welding robot has no gas flow. Already changed diffuser, cone, regulator as well as fuses. Seems like there is gas getting at least up to the feeder but for some reason it isnt coming out the nozzle. I am out of ideas so anything is helpful.
No Gas Flow
- EPeters1
- Thread is Unresolved
-
Is your feeder working? Can you jog wire +/-?
-
Check the selonoid wires on the back of the feeder. or could be a bad selonoid. This turns on the gas flow on and off.
They sometimes wont work when the become covered in metal dust also.
-
When you turn on the gas output from the robot, do you hear the solenoid click?
-
Is the hose lead where the cable hose mounts into the feeder push all the way into the receiver on the wire feeder and the screw tight.
If it is not pushed in all the way the gas ports will not line up.
-
I just wanted to clarify my last post. Was saying to check where the cable hose that goes to the welding torch goes into the wire feeder was pushed all the way in and the screw was tight. We have had that work its way loose in the past. Glad you are up and running again.
Advertising from our partners
